Tire size comparison

275/65R20 vs 285/65R20

A 285/65R20 is 0.51 in (1.5%) taller than a 275/65R20 and 10 mm (0.39 in) wider. Both fit 20-inch wheels, so the whole height difference comes from the sidewall, which is 0.26 in taller on the 285/65R20. At +1.5% the change is inside the common ±3% guideline: with the speedometer calibrated for the 275/65R20, an indicated 60 mph would really be about 60.9 mph. Ground clearance under the axles changes by about +0.26 in, and the tire turns 9 fewer times per mile (592 vs 583).

Size by size

275/65R20285/65R20Difference
Overall diameter34.07 in (866 mm)34.59 in (878 mm)+0.51 in (+1.5%)
Section width10.83 in (275 mm)11.22 in (285 mm)+0.39 in (+3.6%)
Sidewall height7.04 in (179 mm)7.29 in (185 mm)+0.26 in (+3.6%)
Circumference107.05 in (2,719 mm)108.66 in (2,760 mm)+1.61 in (+1.5%)
Revolutions per mile592583−9
Rim diameter20 in20 insame

Inch equivalents: 275/65R20 ≈ 34.1x10.8R20, 285/65R20 ≈ 34.6x11.2R20.

Open in the interactive comparison →

At a glance

285/65R20 vs 275/65R20+1.5%Within ±3%
275/65R20 · 34.1 in285/65R20 · 34.6 in10.8 in11.2 inTread viewSide view

Drawn to scale from calculated dimensions. Left: side view; right: tread view. Dashed line marks the top of the taller tire.

Speedometer difference

With a speedometer calibrated for the 275/65R20, this is your real speed on 285/65R20 tires.

Speedometer showsActual speed with 285/65R20Difference
20 mph20.3 mph+0.3 mph
30 mph30.5 mph+0.5 mph
40 mph40.6 mph+0.6 mph
50 mph50.8 mph+0.8 mph
60 mph60.9 mph+0.9 mph
70 mph71.1 mph+1.1 mph
80 mph81.2 mph+1.2 mph

Fitment considerations

  • Width: the 285/65R20 is 0.39 in wider in section width, so each sidewall sits roughly 0.20 in further out on the same wheel. Check clearance at full steering lock against the upper control arm, frame and fender liner, and confirm your wheel width is inside the tire maker’s approved rim-width range for the 285/65R20.
  • Height: the extra 0.51 in is a modest change, but still check the gap at full compression and full lock, especially with aftermarket wheels or added weight.
  • Speedometer: a 1.5% change is small, but it adds up on the odometer: 1,000 miles shown would be about 1,015 real miles.
  • Load rating: match or exceed the load index (and LT load range, if applicable) on your door placard. P-metric and LT tires of the same size are rated differently.

These checks are general; whether a size fits a particular vehicle depends on its suspension, wheels and body. Your door placard lists the approved original sizes, and a tire professional can confirm fitment.

How these numbers are calculated

Diameter = 2 × section width × aspect ratio ÷ 100 ÷ 25.4 + rim diameter (for inch sizes, the first number is the diameter). Revolutions per mile = 63,360 ÷ (π × diameter). Actual speed = indicated speed × 34.59 ÷ 34.07. Real tires vary by brand and model, so treat these as close estimates and use manufacturer specs for exact measurements.

Frequently asked questions

How much bigger is 285/65R20 than 275/65R20?

285/65R20 is 0.51 inches (1.5%) taller in overall diameter (34.07 in vs 34.59 in) and +0.39 inches in section width.

Will my speedometer be off with 285/65R20 instead of 275/65R20?

Yes, by about 1.5%. If the speedometer is set up for 275/65R20, it will show 60 mph when you are really going about 60.9 mph.

Is 285/65R20 within 3% of 275/65R20?

Yes. The diameter difference is +1.5%.

Check before you buy. Results are calculated from size codes and standard formulas; real tires vary by brand and model. Always check your vehicle placard and owner’s manual for approved sizes and load ratings, and ask a tire professional about fitment and clearance.